Table Saw 360

Here’s a confession every woodworker eventually makes: the first time someone said “just clamp on a sacrificial fence,” you nodded like you understood, then went home and stared at your table saw’s rip fence wondering what exactly you were supposed to sacrifice. You’re not alone, and honestly, the terminology in this hobby seems designed by … Read more

Your cabinet saw is the anchor of the shop — heavy, accurate, and honestly a little smug about it. But the factory fence bolted to it is usually just… fine. It rips straight, it locks down, and it does the bare minimum. A fence accessory kit for cabinet saw owners is how you close that … Read more

Somewhere in every woodworker’s shop there’s a moment of quiet betrayal: you measure twice, cut once, and the board still comes out three-sixteenths short. Nine times out of ten, it isn’t your tape measure or your eyeballing — it’s your fence. A stock table saw fence is basically a straightedge with delusions of precision, and … Read more

There’s a specific kind of frustration that only table saw owners understand: you finally get a clean, dead-straight rip going, and then the tail end of an 8-foot board droops off the back of the table like a fishing rod with something heavy on the line. That sag doesn’t just look awkward — it pulls … Read more

Run a dado stack an inch into a $300 aluminum extrusion fence exactly once, and you’ll understand why woodworkers have been screwing throwaway boards onto their saws since the stacked dado set was invented. It’s a five-minute fix for a mistake that costs a lot more than five minutes to undo. A sacrificial fence for … Read more

Somewhere in every woodworker’s shop there’s a drawer full of half-finished jigs — a crosscut sled with no stop block, a taper jig held together with hope and hot glue, a featherboard clamped on with a C-clamp that slips every third cut. The fix for almost all of it is the same humble strip of … Read more

Here’s a confession every woodworker eventually makes, usually through gritted teeth: you tapped the fence a hair too far, ripped a board, and now it’s 1/32″ shy of what you needed. Again. A fence micro adjuster for precision cuts exists specifically to end that ritual — it swaps the rubber-mallet guessing game for a dial, … Read more

Here’s a confession every woodworker eventually makes: at some point, you’re going to run your blade straight into your table saw’s rip fence. Maybe you’re sneaking up on a dado width, maybe the workpiece shifted a hair, maybe you just got cocky. Sacrificial fence boards for table saws exist precisely for that moment — a … Read more

You know the dance. You nudge the fence, lock it down, make a test cut, and the board comes out 1/64″ fat. So you unlock, tap the fence with your palm — gently, you swear — lock it again, and now it’s 1/32″ skinny. Rinse, repeat, mutter. A micro adjustment fence accessory under $50 is … Read more

The first time a full sheet of 3/4-inch cabinet-grade plywood buckled off the end of my stock table saw fence, I learned something the manual never mentioned: a 24-inch fence is basically a suggestion once you’re dealing with 4×8 material. A table saw fence extension rail kit for large panels solves a specific, annoying problem … Read more